Replacement Of Sand With Steel Slag In Concrete

المنتجات الساخنة

Experimental Study on Steel Slag and Slag Replacing Sand in Concrete

网页2008年12月28日  By means of orthogonal design, this study replaces sand with the steel slag and slags of Handan to compare the concrete made of steel slag and slag with

Contact

A Study on Steel Slag Replacing Sand in Concrete IEEE Xplore

网页2018年11月24日  The recent years in Vietnam, the price of sand increases double. Thus, people are looking for another resource replacing sand. On the other hand, steel slag is a

Contact

Properties of concrete with partial replacement of steel slag

网页Steel slag, one of the by-products obtained from manufacturing of iron and steel which can be used as partial replacement for fine aggregate in concrete thus by reducing the

Contact

Copper slag as sand replacement for high performance concrete

网页2009年8月1日  The workability of concrete was assessed based on the measured slump of fresh concrete. It is clear from Table 2 that the workability of concrete increases

Contact

A Study on Steel Slag Replacing Sand in Concrete

网页2018年11月1日  The primary objective of the project is to increase the strength of the concrete by replacing coarse aggregate by steel slag and also 30% replacement of eco

Contact

STEEL SLAG AS REPLACEMENT OF FINE AGGREGATE IN

网页2018年10月11日  concrete development. The present research work deals with a view to develop efficient concrete by addition of steel slag to evaluate the effectiveness of the

Contact

EXPERIMENTAL ANALYSIS OF CEMENT CONCRETE

网页2021年10月9日  assessed by partially replacing sand with iron slag. The sand has been replaced by slag accordingly in the range of 0% (as a control mix) 10%, 20%, 30%,40%,

Contact

EFFECT OF PARTIAL REPLACEMENT [20%] OF SAND BY

网页2022年7月22日  The quantities of cement, coarse aggregate (20 mm), fine aggregate, steel slag and water for each batch i.e. for different percentage of steel slag replacement was

Contact

Partial Replacement Of Fine Aggregate Using Steel Slag

网页2021年8月10日  various replacement level of steel slag with fine aggregate. The use of steel slag aggregates in concrete by replacing natural aggregates is a most promising

Contact

(PDF) Evaluation of Steel Industrial Slag as Partial

网页2019年2月1日  Concrete specimens containing 0%, 5%, 10%, 20%, 30%,40% replacement of cement by steel slag were prepared and used for the analysis performed in this study. Moreover, the tests were conducted

Contact

Copper slag as sand replacement for high performance concrete

网页2009年8月1日  The workability of concrete was assessed based on the measured slump of fresh concrete. It is clear from Table 2 that the workability of concrete increases significantly with the increase of copper slag content in concrete mixes. For the control mixture (i.e. Mix 1), the measured slump was 28 mm whereas for Mix 8, with 100% replacement of

Contact

Copper or ferrous slag as substitutes for fine aggregates

网页2018年11月1日  sand with iron slag or copper slag. However, 40% replacement of quarry sand with iron slag or copper slag in concrete is recommended considering the durability aspects of concrete. Keywords: slag; concrete; replacement; strength; durability; fine aggregate 1. Introduction Excessive mining of river sand for construction activities is a

Contact

(PDF) Recent Trends in Replacement of Natural

网页2018年2月17日  The replacement of sand with stone dust at various ratios in medium-grade concrete showed an increase of up to 40 and 29% in compressive and up to 53 and 32% in flexural strengths for 7- and 28

Contact

Steel slag as a substitute for fine aggregate in high

网页2022年3月7日  implementation of Steel slag as an effective replacement for sand. Steel slag, which is considered as the solid waste pollutant, can be used for road construction, clinker raw materials, filling materials, etc. In this work, Steel slag is used as replacement for sand, which is also a major component in concrete mixture.

Contact

What are the Materials for Replacement of Sand in

网页2023年7月19日  Granulated blast furnace slag is a waste of steel industry; its use can be best exploited as part replacement of sand in concrete. It can replace sand to the amount of 70 % in concrete mixes. Its Availability is

Contact

Experimental investigation on partial replacement of steel slag

网页2021年1月1日  The first part of this investigation is the partial replacement of M−sand by steel slag with certain percentage. Mix M0 denotes the mix, with 0% steel slag (conventional control mix), M1 denotes mix. With 10% steel slag, M2 denotes mix with 20% steel slag and M3 indicates that mix with 30% steel slag.

Contact

A STUDY ON PARTIAL REPLACEMENT OF CEMENT WITH

网页2019年3月30日  granulated blast furnace slag is better replacement of cement than various other alternatives. The rateof strength gain in slag replaced concrete is slow in early stages but with proper curing the strength goes on increasing tremendously. The compressive strength decreases when the cement replacement is more than 50%. Use of slag or

Contact

STEEL SLAG AS REPLACEMENT OF FINE AGGREGATE IN

网页2018年10月11日  concrete development. The present research work deals with a view to develop efficient concrete by addition of steel slag to evaluate the effectiveness of the use of steel slag as a partial replacement in sand To replace Sand with various percentages 10, 20, 30, 40% of steel slag waste in M25, M30M35 concrete. Investigation have

Contact

Utilization Of Steel Slag In Concrete as a Partial Replacement

网页2014年4月1日  Kothai and Malathy [14] partially replace fine sand (SG=2.65) with fine steel slag (SG=2.95) in normal concrete and found increment of compressive strength at 5% to 10% when replacement level is

Contact

Steel Slag an overview ScienceDirect Topics

网页Steel slags. Carlos Thomas, Francisco Agrela, in New Trends in Eco-efficient and Recycled Concrete, 2019. 7.1.2 Types and classification of steel slags. Steel slags (SSs) are usually classified according to the type of furnace in which they are produced. The properties of the slag depend on the type of process used to produce the crude steel, the cooling

Contact

Performance evaluation of polypropylene granules: A partial replacement

网页2021年11月1日  Forty-eight paving blocks, forty-eight cylinders and forty-eight beams of steel slag mixed concrete with PP were prepared using a mix design of 1:1.17:3.56 (cement: sand: granite), respectively with water-cement ratio of 0.5 and cured for 7, 28, 56 and 90 days. Concrete samples were tested for compressive, split tensile and flexural strength

Contact

International Journal of ChemTech Research

网页R. Padmapriya et al /Int.J. ChemTech Res. 2015,8(4),pp 1721-1729. 1724 Fig 3 Superplasticiser Optimization of steel slag As per [11] concrete grade chosen in present investigation is M 40 for

Contact

Recent Trends in Advanced Radiation Shielding

网页2022年7月12日  Steel slag from blast furnace slag is commonly used as a cement replacement in RSC and is known as ground granulated blast furnace slag (GGBS) due to its pozzolanic property [17,94,95]. GGBS

Contact

(PDF) SLAGS AGGREGATES FOR ROADS AND CIVIL

网页2015年3月13日  of natural sand in concrete mix design if slag den sity is greater than 1400 kg/m 3 and as 50-75 % r eplacement for lesser densities. Low a mix with steel slag to replace 30% of limestone

Contact

A study on replacement of sand by granulated ISP slag in

网页2017年7月10日  These areas represent cement paste, granulated ISF slag, and natural sand. The results of the conducted EDS tests are summarized in Table 4. Conclusions. The conducted research program and the achieved results allow to draw the following conclusions:-It is possible to create an SCC using ISP slag as partial replacement of

Contact

Effective Utilization of Fly Ash and Steel Slag for Partial Replacement

网页2021年4月30日  The experimental results show that concrete mix with partial replacement (by weight) of cement and river sand with 20% fly ash and 10% steel slag, respectively, could be employed as an alternative to conventional M20 mix.

Contact

Experimental Investigation on Replacement of Cement with Fly-Ash, Steel

网页Here keeping cement replacement constant for a particular mix and varying the replacement of sand for M40 grade concrete mix various tests were carried out. On green concrete slump cone test was conducted to measure the workability and on the hardened concrete compressive strength, flexural strength and split tensile strength was conducted.

Contact

Study of Granulated Blast Furnace Slag as Fine Aggregates in Concrete

网页2015年7月3日  Present experimental work explores the possibility of using GBFS as replacement of natural sand in concrete. In this study an attempt is done to understand the variation in compressive strength of concrete with GBFS content. Durability and mechanical properties of high strength concrete incorporating ultra fine Ground

Contact

The implementation of scale and steel chips waste as a replacement

网页2016年11月20日  Table 3 present moisture content and density of scale and steel chips. Concrete production. The concretes were produced in two different types, using scale and steel chips waste from the iron and steel industry as a partial replacement for sand. These were determined in terms of mixing aggregate as a sand substitute. If scale waste was

Contact